Guyinatree Posted April 23, 2018 Report Share Posted April 23, 2018 Been doing a ton of cutting with the chop saw and was wondering if anyone had found a use for the scrap wheels instead of throwing them out. In a single day I’ll have 9 or 10 scrap wheels that get tossed but there is still a good amount of meat on them (10”). Has anyone found a use for them on smaller grinders? Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
method Posted November 23, 2018 Report Share Posted November 23, 2018 Depending on their rated speed you could use them on a smaller hand held saw. You should look at a tungsten cold saw if you go through that many wheels, it would pay for itself in a few days. Quote Link to comment Share on other sites More sharing options...
paulengr Posted December 1, 2018 Report Share Posted December 1, 2018 Depending on their rated speed you could use them on a smaller hand held saw. You should look at a tungsten cold saw if you go through that many wheels, it would pay for itself in a few days.Be very careful about wearing down. Cutoff wheels won't survive this and fly apart eventually if you get small enough. That's ok until a piece wedges itself an inch into your thigh.Sent from my SM-T350 using Tapatalk Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.