SetBuilder Posted June 17, 2018 Report Share Posted June 17, 2018 I made a little down and dirty router table today making some base board trim for my house. I set the router up in the middle of a 8ft work table. With a roller stand on each end I was able to easily manage 16ft boards. 2 Quote Link to comment Share on other sites More sharing options...
ChrisK Posted June 17, 2018 Report Share Posted June 17, 2018 Like it a lot plus great table support. What are you using to hold the feather boards in, are there a few slots in place? Quote Link to comment Share on other sites More sharing options...
SetBuilder Posted June 17, 2018 Author Report Share Posted June 17, 2018 I ended up switching it so the bottom of the board was against the fence. One one of the passes a bit of primer got embedded in the fence and put a groove in the top of the board. If the groove is on the bottom it goes against the floor. i just used construction screws and fender washers for the feather boards. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.