Jump to content
  • Cresent.jpg

pcooper

PSB18-Li2 . Drill , battery or charger problem

Recommended Posts

When i come to use it ive got 3 flashing lights and nothing going round.

When i put it in the charger  the charger green light doesn't come on , but the drill works (2 battery charging status lights)

 Where is the problem - drill , charger or battery  ?

 

 

Share this post


Link to post
Share on other sites

I had exactly the same problem with my drill and was about to give up on it.

However, I noticed that it was a bit damp after being stored in the garage, so suspected that some moisture was affecting the electronics.

Here's what I did to get it working again:

I undid all the screws in the casing and separated the two halves. At the bottom by the battery connector is a small circuit board. I removed this (still attached to the wires) and used a hair drier to blow it with hot air all over for a few minutes. Make sure you blow all around the little chips - this is where I reckon the moisture was getting and upsetting the circuitry that controls the speed. more details

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Member Statistics

    13,882
    Total Members
    414
    Most Online
    Pool Dude 86
    Newest Member
    Pool Dude 86
    Joined
×
×
  • Create New...