Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 01/25/2020 in all areas

  1. @liverpool5 my suggestion may not be exactly what you want but I will go ahead and tell you anyway. May I ask what the saw is doing? Does it stay put in a shop or does it move from jobsite to jobsite? If it moves from jobsite to jobsite you can buy a portable dust shroud/hood that basically covers the whole rear of the saw. It would look something like this. It maybe isn't the dust port you are looking for but it would serve the same purpose to contain and collect the dust as much as possible. If your saw stays put in a shop it might be a better option just to add a custom shroud/hood out of plywood with your dust extractor hooked up at the bottom.
    1 point
  2. The Planer is here! Biggest changes: 3mm cut depth, brushed was only 2mm 25mm rebate, brushed was 9mm dual port dust extraction AWS Batt gauge Torque control Quite a lot of changes! My review:
    1 point
  3. eBay had a sale going on and a picked up the sunex master metric impact set got it for $100 Sent from my ONEPLUS A6013 using Tapatalk Lol wrong thread
    1 point
  4. Welp I'm just about done with a remodel after the client had a fire. We took this house down to the studs and changed the floor plan to open up the kitchen and living room and also increase from 2 bedrooms to 4. I just have to redo to front and rear decks then it's complete.
    1 point
×
×
  • Create New...