nyjumpee

Hey Wingless! Thanks so much for not only the Welcome but the awesome, quick response! I don't know all of the correct terminology but am pretty sure I understand what you're saying to do. I can smooth out the outer surface of the commutator. Not exactly sure what I'm looking for regarding clean segment gaps and how to ensure that they're not shorted. Does that just mean that they're not touching each other? The ends of the original brushes looked pretty good. The brushes themselves were worn short of course but looked okay. The reason I replaced them was that on one of them, the wire that connects the brush to the metal end-cap was broken so I'm sure it wasn't functioning. When I replace them with new brushes, the new ends weren't rounded off to match the curve of the commutator but squared off. Upon a few seconds of running and sparking, now they're broken-off on the ends and jagged. I'm guessing it's a new set of brushes at least that I'm looking at? Anyway, I'll get that sucker apart and start what you suggested and I'll get some pictures posted as well. Thanks again so much for your help! 🙂

I have a DW359 that's been used very little over it's lifetime. I was just using it to make a few plywood cuts and I noticed the RPM of the motor slowing down. I took a look and saw pretty big sparks. I stopped the saw, pulled the brushes and they looked worn. Ordered and installed new brushes. . still sparking like crazy and noticed the new brushes are already wearing and the motor still smelling after only a few seconds of running. Took a bit closer look and notice a small "hangup" on the brushes at a certain point each revolution of the "commutator" (if that's the right term) and looks like the new brushes are "chipped" at the ends! What is causing the excessive sparking and is there anything I can do, (sand, etc) to stop the brushes from getting knicked and chipped? The saw is otherwise in great shape. I looked online and see the parts it needs, armature, etc. may not be available anymore. Is there anything I can do to see if I can get this baby running right again? Thanks in advance! 🙂

Hi! I'm doing a lot of superficial rust removal from 2 1/2" x 1 1/2" rectangular steel tubing. I've been using my DeWalt 4 1/2" DW402 7.5 amp angle grinder with a 5" wire wheel on it but it's old and bogging down so I'm in the market for a new angle grinder. Also, It seems that the RPM on the angle grinder exceeds the RPM on any wire wheel that I've been able to find. . .seems most wire wheels are made for Bench Grinders with lower RPM? Since I'm doing so much grinding/wire wheeling, I'd like to step up to a higher amp and larger angle grinder to help speed up the process and also step up to a larger wire wheel. .6" or 7". What are my options for wire wheels for a larger angle grinder? Thanks in advance!