Good day folks. I recently had to replace the slider in my BJR182. I have it in place and am now struggling with the chuck. According to assembly diagrams I have seen online, I believe I have all the pieces in the right order and positions. However, I cannot seem to get the driving sleeve to slide over the guide sleeve far enough to match up with the driving sleeve guide and sleeve. I am aware of the notches on the guide and sleeve for the bump outs in the driving sleeve. I also understand the the ramped portion of the driving sleeve in regards to putting pressure on the shoulder pin and compression spring. I just, for the life of me, can't get the the driving sleeve to cooperate with e the guide and sleeve. Anyone run into this difficulty?
