Jump to content

oliverw

Members
  • Posts

    3
  • Joined

  • Last visited

Everything posted by oliverw

  1. Okay I took a chance and connected two of the four motor wires (which I believed to be correct) to mains. Motor runs fine. It will now be switched off/on directly via circuit breaker. This means I've bypassed the over-heat sensor and maybe something else but I need the saw to work. By the way I did test the switch and it was working correctly. Thank you very much for your interest.
  2. What I mean by other components are those within the electrical housing under the table. I'd like to connect directly to mains because I suspect that a part has blown, motor will not start. Motor seems healthy though when tested with ohm meter. I'd like to power the motor directly from 220v using my own switchgear. Thank you
  3. Hi I need to rewire this table saw. Does anybody know about the 4 wires coming from the motor? I would like to bypass the other components so that I can have a direct connection to mains, or does the motor need other components to run correctly? thanks in advance
×
×
  • Create New...