-
Posts
1,048 -
Joined
-
Last visited
-
Days Won
7
Content Type
Profiles
Forums
Events
Everything posted by CATERPILLAR
-
Oh damn I dont check the makita website .
-
Usually just change it if it's getting old or looks dirty. Try and see what the manufacturer uses . Also dont over fill .
-
If you still need help I might have the gear if you can send a picture
-
It's really not worth bothering with
-
Just buy one off of ereplacementparts. I'm sure it will only be around 20ish bucks
-
No they look alright. Make sure they are still making contact and the spring keeps tension on them. Do the commutator bars look ok still ?
-
Best bet is Ebay or buy a used one for parts
-
Pop off the c clip , take off the lever then tighten the nut until it is tight enough to hold but not too tight that you can't use the lever to loosen it. Then put the lever back on and pop the c clip back on.
-
No that's not that big of a deal because it doesn't make a huge difference what's important is left to right so it cuts straight and doesn't get kinked up.
-
Wish you the best luck . Alot of times they never go back the same if not just buy a whole new gear box .
-
The next steps to follow after you checked the power source & brushes.
CATERPILLAR replied to SethS's topic in Power Tools
Did you go over the cord ? Test the cord from end to end. I've seen where there wasn't a physical cut or anything but it was on the inside and the wire just pulled out. Next check the switch . If there is a way to bypass it do that so its directly hooked up. Test the switch to see if it works when the trigger is squeezed. Also make sure the brushes are making good contact.- 1 reply
-
- dewalt dw718
- compound miter saw
-
(and 1 more)
Tagged with:
-
Does it hum or anything ? Check the easiest things first like the cord then the brushes . Make sure they are making contact with the armature. Also look at the commutator bars while the brushes are out to see if it's in good condition , is it belt driven if so check the belt ? . If non of these are it see if you can bypass the switch so its directly on with alligator clips of something similar.
-
You can try and squeeze it out with some pliers if you are gentle and if it's too messed up I'd just get the collet out and buy a new one off of ereplacementparts
-
Such a strange knock off ! Lol
-
I seen that can't wait till it comes to the us . Hopefully it does
-
DC18RC charger - repair/replace? (Water damage?)
CATERPILLAR replied to BartGojjer's topic in Makita
Just buy a new one $30 on Ebay.- 4 replies
-
- repair
- water damage
-
(and 1 more)
Tagged with:
-
If just buy a new ones yes you can by the parts and I do that for alot of my stuff but from what yours has gone through better to just start out fresh .
-
I'm hopefully getting a Makita LS1400 in the next couple days. Is there anyone on here that knows of any good 14inch blades and where to buy ? I have found a few but there's really nothing out there .
-
The screw is tighter down all the way too you need to adjust it while running it . That way it won't fall off.
-
I hate hate taking gear boxes apart because alot have one certain way they go back together. Glad to see other people repairing tools
-
Damn that looks good .
-
Can you send pictures ? And did this just happen all of a sudden or when you went to use it ?
-
-
Your best bet is to keep your eye out and check eBay also.