Jump to content

Tyson1987

Members
  • Posts

    2
  • Joined

  • Last visited

Tyson1987's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. I have had the same problem with my dewalt drill until i stumbled across how to use keyless chucks properly (incase your in the same position) when you tighten the chuck all the way up, loosen it off just one click. This actually locks a keyless chuck in properly and stops the drill bits from spinning. Then when removing drill bit just tighten back up one click again before loosening chuck. May seem common knowledge to some but literally no one I've talked to since finding this out knew anything about it haha good luck
  2. I have recently had the same issue with my saws, I found 2 ways to correct it. it seems to be as though the connection on the back end of the saw could be better and either bends up or just has to much movement in it and it’s not as much it can’t go back square as it just can’t when the bench is flat down because it hits the back end of the motors/body and then won’t go any further. So a simple fix is to realease the bench lower set to 0 and then bring bench back up. Usually it’ll stay in spot till you adjust bench and angle at the same time. the other fix is to put a thin washer in between the bench plate and the angle adjustment housing to help drop the front just enough that it clears that back part. Worked a treat. hope that helps 👍🏻
×
×
  • Create New...