Jump to content

Tony Trott

Members
  • Posts

    2
  • Joined

  • Last visited

Tony Trott's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. I have most of my M12 kit in a systainer that I take into virtually every job with me. This has a sawzal, impact driver, installation drill driver and Jigsaw. The Jigsaw is a fab addition to this set for the odd notch in a kitchen cab, or cutting the odd batten or something. I have used it to lay laminate flooring but it does need a blower for sure and also it would benefit from pendulum action to speed up the cutting. It’s fab for the odd cut but not one to have on its own without the M18 for heavier duties or an electric one to step in where the M12 falls short.
  2. Hey guys, I’ve had the same problem of the planer blades protruding lower than the rear base plate. Therefore when you make a pass it takes a dip at the end of the workpiece. There isn’t any adjustment to rectify this. If you remove the blades you will see a milled recess in the cutter block that determines the blade position. I have altered this with some patience and some needle files and now the blades are set correctly as they should be. It is frustrating and I’ve never had this with any other planer I’ve ever owned.
×
×
  • Create New...