Hi
DW745 Table-saw purchased 2020 from new..
I went to adjust the mitre cut on it today and it wouldn’t adjust to 45 degrees.. 49 was the best i could get..
Obviously i checked all the normal things etc, checked the blade at 90 degrees with a digital gauge and fine, but release the lock handle and slide to change angle and it comes to a halt like it’s up against something short of 45..
Took the blade and riving knife out took plastic side panels off and cleaned everything thoroughly plus blew out dust with comp air and WD40 etc but no luck.. Just can’t see what’s stopping it from reaching the desired angle.. it’s not hitting the stops when going for the 45 but it does so just fine when going for 90..
Any of you guys had a similar experience ?
Many thanks
Noods