Stepping Up The Dust Control...

[comp56]

picked myself up a better solution for dust control, 2HP 1200 CFM with 1 micron bag. I am going to make this single stage collector into a dual stage with adding a cyclone eventually..

 

 

[Foneguy]

DAMN !!!!!!!

?????

[Foneguy]

I went to HD today looking for this,

(and I thought this was an upgrade)

i have to order it.....

 

[CATERPILLAR]

19 minutes ago, comp56 said:

picked myself up a better solution for dust control, 2HP 1200 CFM with 1 micron bag. I am going to make this single stage collector into a dual stage with adding a cyclone eventually..

 

 

Very nice man is it standard 4 inch 

[comp56]

it can be but it starts out as 6" then it has an adapter for 2 - 4" ports I only have 4" hose so ya it will be 4" to table saw and miter saw

[comp56]

calculated the angles to make a sheet metal cyclone basic size will be 30" tall 24" at the top and 12" at the bottom. with a 4" out port on top and a 4" intake port on side.

I have the sheet metal just have to cut it and weld it up.....suppose to be around 50+ degrees all next week so hopefully will get it done then ( want to do the cutting and grinding and welding outside for obvious reasons) 

 

might even go a little smaller and follow the size of this metal one

[Foneguy]

Can't wait to see it

[Logan]

You will definitely be happy after the first use by not having dust everywhere and breathing it in

[comp56]

40 minutes ago, Logan said:

You will definitely be happy after the first use by not having dust everywhere and breathing it in

well my 6.5hp shop vac and dust deputy wasn't that bad.....lol but I am hoping for an improvement 

 

 

[KnarlyCarl]

Looks like your guaranteed an improvement already.... I really want to get a cyclone for the shop dust collection unit and maybe move it outside in a little enclosure of its own