Jump to content

The next steps to follow after you checked the power source & brushes.


Recommended Posts

I recently received a Dewalt DW718 that was giving to me by a buddy because it didn't work. I already have changed the brushes (nothing) and armature only because it was given to me. I need a little advise as far as what steps or what should I go about doing next. I really would like to get it going because I could put it to good use or sell it & try to make a little profit off of it. What do y'all think?

Link to post
Share on other sites

Did you go over the cord ? Test the cord from end to end. I've seen where there wasn't a physical cut or anything but it was on the inside and the wire just pulled out. Next check the switch . If there is a way to bypass it do that so its directly hooked up. Test the switch to see if it works when the trigger is squeezed. Also make sure the brushes are making good contact.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Member Statistics

    14,877
    Total Members
    859
    Most Online
    BlueStreak
    Newest Member
    BlueStreak
    Joined
×
×
  • Create New...