Jump to content

ryobi miter saw turntable not level


guyfoxday

Recommended Posts

I recently picked up a Ryobi 10 in. Compound Miter Saw 14amp and while I understand how to make all the blade and fence adjustments, the actual turntable is not precisely level with the base (the non-turnable "no hands area").  On the left side the difference is about 1/16 inch so that when i clamp a board, it doesn't sit level on the turntable and the cut is ever so slightly off.  Anyone know how to make this adjustment?

Thanks

20200228_100401.jpg

20200228_100446.jpg

Link to comment
Share on other sites

  • 5 months later...

I have the same issue and do not have an answer but, I am going to try to turn the entire saw upside down to see if there is any excess sawdust or other wood shavings that might be raising the turntable portion as it is slightly higher than both no hands sides.  Sounds very similar to your issue.  I see that no one has answered this yet.  Maybe someone reading this may have some other thoughts.

 

  • Confused 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Member Statistics

    18,154
    Total Members
    6,555
    Most Online
    garikb
    Newest Member
    garikb
    Joined
×
×
  • Create New...