Bertl Posted June 27, 2020 Report Share Posted June 27, 2020 I've got this older ryobi 410r tiller. hadn't used it for along time. replaced the bulb and lines and filter and bang started like a new machine. used it abouta week and hadn't used the kill switch to shut it down. i did however use that kill switch the last time i used it. now i can't get to start. took the spark plug out to check for spark and nothing. any body got any ideas ? Quote Link to comment Share on other sites More sharing options...
Eric - TIA Posted June 28, 2020 Report Share Posted June 28, 2020 Are you using fresh gas? If you have bad gas, it can gum up quickly and not start. Quote Link to comment Share on other sites More sharing options...
Bertl Posted June 29, 2020 Author Report Share Posted June 29, 2020 Forgot to mention that. Fresh gas/oil mix. Just not getting any spark. Quote Link to comment Share on other sites More sharing options...
Eric - TIA Posted June 29, 2020 Report Share Posted June 29, 2020 That is weird. I take it the spark plug wire is in good condition? I am stumped why you are not getting any spark. Have you tried cleaning the inside of the wire that sits on top of the spark plug to make sure there isn't any corrosion? Quote Link to comment Share on other sites More sharing options...
Bertl Posted June 29, 2020 Author Report Share Posted June 29, 2020 Have not. Any chance that the ignition coil shot craps. I will check the plug connector when I get a chance Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.