Mick welsh Posted September 10, 2020 Report Share Posted September 10, 2020 I have a dcs7485 table saw. When I start it and take my finger off the start button, it stops. If I keep the button pressed in it will run as normal. Does anyone know if it’s a simple switch to change or something else... any advice would be very welcome. mick Quote Link to comment Share on other sites More sharing options...
Eric - TIA Posted September 10, 2020 Report Share Posted September 10, 2020 Mine had been running good. I have never had to change or mess around with the switch but I would assume that as along as you are holding the switch down and it's running, it would probably be the switch. Quote Link to comment Share on other sites More sharing options...
framer Posted September 11, 2020 Report Share Posted September 11, 2020 when you take your finger off, are you making sure the red flap is not swinging down and hitting the stop button? Quote Link to comment Share on other sites More sharing options...
Mick welsh Posted September 11, 2020 Author Report Share Posted September 11, 2020 2 hours ago, framer said: when you take your finger off, are you making sure the red flap is not swinging down and hitting the stop button? Haha.. had the saw for 2 years.... I know how to use it properly. Thanx tho Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.