CharlieG Posted March 7, 2021 Report Share Posted March 7, 2021 I have a 1/2" Milwaukee Hammer drill, 2602-20. I am trying to replace the keyless chuck but can't seem to get to the screw to take the chuck off. As best as I can tell, it looks like a torx screw. But I've tried a #10 and #15 and neither grab it. Even tried grinding down the shaft on the driver to get to the screw. Tried blowing out any gunk. Tried an M6 allen wrench. No luck at all with anything. Any ideas? Quote Link to comment Share on other sites More sharing options...
Bricktop Posted April 5, 2021 Report Share Posted April 5, 2021 The way I removed that screw on mine (2704) was use a short impact bit extension and one of the torx bits that was provided in a Milwaukee shockwave impact driver set Milwaukee I had. The set is a several years old now but it had lots of torx bits, phillips, and lots of other stuff. Not sure what the size was but it was one that came in the set. It came right out. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.