Jump to content

repairing 1950s table saw


jon burgess

Recommended Posts

I have 2 question one how to take off my aluminum pulley the screw us out. I don't have much tools. My other question should I keep the bearing or get new ones? i believe that they are the original ones

 

its not letting upload a pic of the pulley but its on the motor.

 
 
Link to comment
Share on other sites

get a pipe about same size as center of pulley, long enough to tap pulley farther down shaft, if you can..... sand shaft from where pulley is to end of shaft that it will come off of. .

Link to comment
Share on other sites

I think any motor would work as long as it's at least 1/2 HP and same RPM. And the bolt holes lined up would be helpful, but not necessary

Although I know two motor shops around here I would want them to repair the motor to keep it original. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Member Statistics

    18,156
    Total Members
    6,555
    Most Online
    Ballen1114
    Newest Member
    Ballen1114
    Joined
×
×
  • Create New...