AlanM

I have a Ryobi One+ R18CS circular saw (standard blade - 165mm, thin kerf, 16mm bore, 24 tooth blade) I am intending to cut quite a lot of melamine faced board (wardrobe doors and drawer faces). I have been told that for a good finish I need to get a 60-72 tooth cross cut blade. Ryobi do not seem to do one. Can you advise me who's blade is best and would fit? [There seem to be many blade suppliers, but I am assuming many will be poor quality/short life, but do not know which are not!]. Thank for any advice.

I have a Ryobi One+ R18CS circular saw (standard blade - 165mm, thin kerf, 16mm bore, 24 tooth blade) I am intending to cut quite a lot of melamine faced board (wardrobe doors and drawer faces). I have been told that for a good finish I need to get a 60-72 tooth cross cut blade. Ryobi do not seem to do one. Can you advise me who's blade is best and would fit? [There seem to be many blade suppliers, but I am assuming many will be poor quality/short life, but do not know which are not!]. Thank for any advice.