Hi.
I use the Bosch GSR 12V-30 with hex shaft sanding pads for sanding in very tight spaces. Even this wonderful little tool on occations turns out to be too large for the job.
I've been looking at the GWG that looks to be even shorter, but it comes with collet chucks in different sizes.
Turning down the hex shaft to the right diameter would still add to the lenght of the tool and possibly rob the project of meaning.
1) Is it possible to hold a standard ¼" hex shaft with one of the collet sizes?
2) If not, would it be possible to "hack" the tool and mount a standard ¼" hex holder instead (and live with the impact on guarantee)?
Thanks for any answers, ideas or hints to a solution, you might offer.
Lars in Denmark
