Chiefifd Posted September 10 Report Share Posted September 10 Hi All.... My first post here. I have a MILWAUKEE 18Volt drill/hammer drill, the chuck was bad and I'm replacing it. *(I hate Milwaukee drill chucks ). Now I did get the chuck off the drill, however it was a challenge. I had to use heat and basically cut off the chuck. My problem is I need the I'll call it a dust cover/gasket it's made of plastic. It's the part between the chuck and the motor, it's not shown on any parts diagram. On the Milwaukee parts diagram it's between part #53 & #2 the chuck, it doesn't show the dust cover/gasket. The part melted while taking the chuck off, so I'm looking for the part. Can anyone point me in the right direction? Thanks for any help. Quote Link to comment Share on other sites More sharing options...
Chiefifd Posted September 10 Author Report Share Posted September 10 I've added photos of the drill. You can see in the first photo where the dust cover/gasket goes on then the chuck. Thanks for any help... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.