jim500 Posted May 13, 2010 Report Share Posted May 13, 2010 My new 14.4v xrp nailer jams after every fire, once i relelease the jam release clasp it fires another nail then jams again. when i say jams i dont mean that a nail is stuck it just wont fire another nail until i release the jamming mechanism, when i release it i can here something clicking back the it fires again. hope this makes sense. its a dc612 thanks Jim Link to comment Share on other sites More sharing options...
kanxrus Posted May 19, 2010 Report Share Posted May 19, 2010 Two options. Are you using the correct nails? If you are, then I would either exchange it. Or take it in and have it repaired. Link to comment Share on other sites More sharing options...
charimon Posted May 30, 2010 Report Share Posted May 30, 2010 sorry i did not look here earlier. You most likely have it set to sequential fire mode. There is a small switch in front of the trigger move it to the other position and that should take care of your problem Craig Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.