xenahank Posted December 16, 2011 Report Share Posted December 16, 2011 Hi, I just got a DW715 and absolutely love it. I am going to order the clamp, but wonder if there any time that I would use 2 instead of just 1 clamp when cutting. Thanks! Link to comment Share on other sites More sharing options...
kanxrus Posted December 16, 2011 Report Share Posted December 16, 2011 If you were cutting a very long piece of material you may want to use 2 clamps. That's if the material is longer than your supports, and you run the risk of the piece you are cutting to pop up after the cut. If you have good support on both end's of you material, one clamp would be fine. Link to comment Share on other sites More sharing options...
xenahank Posted December 16, 2011 Author Report Share Posted December 16, 2011 Hi Dewaltdude, Thanks so much!! I would rather spend the extra on a nailer... or at least a girl can wish! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.