John R Posted July 22, 2020 Report Share Posted July 22, 2020 I have the p590 18v bandsaw and (almost) love it. The only issue I'm having is EVERY SINGLE CUT I make, the blade binds and derails. I'm am electrician, using it to cut emt conduit, spiral flex, pvc-coated spiral flex and threaded rod (3/8 and 1/4"). It cuts all these things great, but boot until the second attempt. I start the saw off the material, bring the blade into it and poof. About 1/16" into the material, blade binds and comes off the wheel. Put it back on and go again, no problem. Anyone have any ideas to resolve this? I'm almost ready to chuck it and go buy the Milwaukee, and a set of batteries. But I'd rather pay rent, they're about the same. Quote Link to comment Share on other sites More sharing options...
Eric - TIA Posted July 23, 2020 Report Share Posted July 23, 2020 Have you tried to adjust the tracking? There are two set screws on either side of the tension release lever. You just need the hex wrench. Quote Link to comment Share on other sites More sharing options...
John R Posted July 25, 2020 Author Report Share Posted July 25, 2020 I haven't adjusted the tracking yet, although I did think about it. The reason I didn't is that it tracks fine under no load. And after re-installing the blade for the second attempt, it cuts fine. It just doesn't like that fresh cut for some reason. Quite odd. Quote Link to comment Share on other sites More sharing options...
Eric - TIA Posted July 27, 2020 Report Share Posted July 27, 2020 Very odd. I would think it has to do with something in one of the wheels. When a load is put on, then something is moving on one of thw heels causing it to lose tracking. I just don't know enough about that tool. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.