Emed2020 Posted December 24, 2020 Report Share Posted December 24, 2020 i got the Skilsaw SPT99 table saw. In my hands, a 'skil' saw is just a saw. I've used a chop and miter saw quite a bit and I've built some outdoor furniture out of builder grade wood, etc. Looking to build some more refined items so I got this table saw. I've watched YouTube Videos about the use of them, and basically they've scared the hell outta me! I'm almost afraid to turn the thing on. I realize a lot of stuff in the manual is written by lawyers to cover their ass, but it's hard for me to distinguish that from what might be important given my complete inexperience around this tool. Based on what I've read so far, the best I can figure, this thing is gonna kill me when I run a piece of wood thru it. I'd prefer that not to happen, being so close to Christmas and everything. Having used chop saws and circular saws, I know about kickbacks...I'm fundamentally against them! But there seems to be a lot more ways for them to occur on table saws. I've aligned the blade (actually I checked it and it is aligned with the miter channels and the rip fence), the riving knife is set up in accordance with the manual. And the rip fence is aligned on both sides at various check points (it's a rack and pinion adjustment system on this saw). I'm very tempted to run some wood thru this saw, but looking for any further warnings I may have missed so far in my research. I did see somewhere that you shouldn't operate the saw after consuming alcohol, so I guess today's out of the question now. Any guidance is appreciated. E Link to saw in question: https://www.amazon.com/SKILSAW-SPT99-11-Heavy-Drive-Silver/dp/B07657FP2G/ref=asc_df_B07657FP2G/?tag=hyprod-20&linkCode=df0&hvadid=241901362930&hvpos=&hvnetw=g&hvrand=8954880505270299164&hvpone=&hvptwo=&hvqmt=&hvdev=c&hvdvcmdl=&hvlocint=&hvlocphy=9010335&hvtargid=pla-589545635245&psc=1 Quote Link to comment Share on other sites More sharing options...
wingless Posted December 25, 2020 Report Share Posted December 25, 2020 Welcome to the forum. That is a nice looking saw. The audible sound from my direct drive table saws has always been very screeching loud, while my belt drive is very quiet. I have never owned or heard a worm drive. How is the sound? A table saw is one of the most useful general purpose tools. The concern for safety is very, very valid. Bad things can happen so much faster than the eye can see or a human can react. There is LOTS and LOTS of info available online. That is a great newbie starting point. Here are some general pointers: always be aware of the location of your fingers and the blade only use one, a rip fence or a miter slide never free hand cut always use a riving knife, purchase or fabricate a modified riving knife (if required) for non through cuts sleds are very handy tools to increase safety and accuracy plan the entire cut, especially important on larger material the usage of push sticks and push blocks is important when appropriate be aware of potential binding conditions, like cross cutting (miter) or ripping (rip fence) on long pieces where control of the angle to the blade is more difficult always wear eye protection, no loose clothing or jewelry, well lit work area w/o clutter, stable saw setup location There are many more safety / usage pointers. My workshop saw is an amazing tool. I also have a direct drive saw w/ stand that I use for remote work. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.