RickyMcGrath

That would likely be the lever for changing the blade. https://www.manualslib.com/manual/39489/Dewalt-Dw321.html

It sounds to me like you are inserting the driver tip directly into the drill. You will need to use the silver 1/4” driver in the drill first. It has a notch at the end designed to lock into the impact. Then the tip goes into the driver and that should be held in with either a magnet or a wire ring inside the silver driver.

Behind the fence on the right side. It’s a spring type clap the aren’t will snap in to. Sent from my iPhone using Tapatalk

did you click the link? It let me add it to my cart. Sent from my iPhone using Tapatalk

https://www.amazon.com/DEWALT-DW717-Double-Bevel-Sliding-Compound/dp/B001AIX5OO/ref=mp_s_a_1_4?dchild=1&keywords=dw717+dewalt+miter+saw&qid=1585142997&sr=8-4

Just buy a new saw. It’s not much more than what a new motor would likely cost you. https://www.toolsid.com/dewalt/14-abrasive-chop-saw-electric-mpn-d28710.html?view=042084&utm_source=microsoft&utm_medium=cpc&utm_campaign=268680567&utm_content=1173179535357969

I just Went into a service center to have my 40v blower repaired and they’re are switching around some model numbers and changing some things. They had a hard time ordering a replacement due to this. https://www.dewalt.com/products/power-tools/shop-by-cordless-platform/40v

Lots of sites have it in stock. Looks like the option with batteries is discontinued though. https://www.dewalt.com/products/gear-and-equipment/generators-and-portable-power/1800-watt-portable-power-station-and-simultaneous-battery-charger/dcb1800b

ah ratings only add negligible amounts of “power.” The key factor is runtime. 6 vs 9, you should see roughly a 50% linger runtime.

I’ll give you that it’s a hair too short but I rip 8’ sheets regularly. There’s a finite amount of wiggle room to set the track on a 8’ rip for it to work properly. Takes a few minutes to figure out but once you do, mark your track so it’s easily setup next time.

Fiber Cement is the generic name. Hardie is a brand name. CertainTeed also makes Fiber Cement siding as do many other manufacturers.

Dewalt makes fiber cement shears. dustless.

Depends on the tool and generation. Nylon PA6 and Polycarbonate & PBT.

Depends on how close the nearest DEWALT Service Centre is from your home. If it was in my area, I’d buy it.

Best way would be to get some 1/4 ply to sheet over the OSB with.

I'm pretty sure all my drill/drivers do if they aren't clamped down on a drill bit or driver.

20v?!?! Where's the 40v?

Not sure. The units at the event don't even have branding on them yet. Probably just final prototype/proof of concept. May be a while.

They have varying sizes. Looks like it's up to 65 qts.