peroxwhygen Posted July 28, 2016 Report Posted July 28, 2016 How can I finish the cut no router table or table saw the block of wood must be there Quote
KnarlyCarl Posted July 28, 2016 Report Posted July 28, 2016 What am I looking at? Sent from my XT1585 using Tapatalk Quote
peroxwhygen Posted July 28, 2016 Author Report Posted July 28, 2016 Micro fence jig to make a straight line with a router. I am make a cabinet that goes underneath my workbench. Sent from my iPhone using Tapatalk Quote
ChrisK Posted July 28, 2016 Report Posted July 28, 2016 I'd disassemble the joint if it's imperative to use the jig or else I would just make a new jig without attaching it to the router base so you can route into the corners. Kind of hard to give you an intelligent answer though without seeing exactly what your trying to do, can you draw something up or move the router and jig aside? 1 Quote
peroxwhygen Posted July 28, 2016 Author Report Posted July 28, 2016 the groove is for the rod that will go into by table legs Sent from my iPad using Tapatalk 1 Quote
KnarlyCarl Posted July 29, 2016 Report Posted July 29, 2016 Ahha I get it now! I would move you fence to the outside of the frame, nothing will get in your way then. Then adjust the guide fence to keep routing where you left off Sent from my XT1585 using Tapatalk 1 Quote
ChrisK Posted July 29, 2016 Report Posted July 29, 2016 Yup, what NotCarl says! You can disassemble the pocket joints too but he's dead on that'd work excellent! 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.