Beebad Posted October 18, 2020 Report Share Posted October 18, 2020 Hi, I am trying to make a bevel cut on my DWS780 mitre saw ( love it). I havent needed to make a 45 degree bevel cut. When I do a dry run I notice that the blade will nick the kerf plate ( yellow). Is this right? Any ideas? Thanks for looking! Quote Link to comment Share on other sites More sharing options...
Eric - TIA Posted October 19, 2020 Report Share Posted October 19, 2020 The Kerf plate should have screws where you can adjust it. Might have been put on wrong. If you can't adjust the plate I would put some painters tape on it and make the cut, as along as the pate is plastic. If it's just nicking it, you should be fine. The tape will help prevent it from cracking etc. Once you make the cut, take the tape off and you should be fine to make the cut you wanted. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.